Skip to content
ASYAM TradingRequest a Quote

Equipment

Sizing a generator against a real load profile

Nameplate ratings describe the machine, not your site. Starting current, duty cycle and altitude derating decide what you actually need.

ASYAM Trading1 min read

Sizing a generator against a real load profile

Generator sizing goes wrong in both directions. Undersize and the set is overloaded every time a large motor starts. Oversize and it runs lightly loaded for its whole life, which on a diesel engine causes its own damage.

Three things a nameplate does not tell you

  • Starting current — a motor can draw several times its running load for a few seconds
  • Duty cycle — prime, standby and continuous ratings are not interchangeable
  • Altitude and ambient temperature — both derate output, and Addis Ababa sits high enough to matter

Altitude derating is the one most often missed on equipment specified abroad. A set rated at sea level will not deliver its nameplate output on a highland site, and the shortfall is not trivial.

What to send when asking for a quote

A list of connected loads with their starting characteristics, the site altitude, the expected ambient range and the duty the set will run. That is usually enough to size properly rather than by rule of thumb.

If that information is not to hand, say so. Sizing from an estimate and stating the assumption is honest work. Sizing from an estimate and presenting it as a specification is not.

Tell us what you need. We’ll price it.

Send a specification, a part number or a rough description — our team comes back with availability, lead time and a landed price.